+10 votes
79 views
in Suggestion by (130 points)
Hey, i think it would be lovely if you could control the bend of a conveyor by using mouse movement.

So you could normally just click place conveyors, or you could hold left mouse button as you place it and then move it left/right/up/down in order to bend conveyors over/under eachother and make curves look nicer by adjusting the position of a third point on the conveyor spline on the orthogonal plane at the center of the conveyor.

This would allow for easier placement of conveyors over terrain, let you cross two conveyors between poles at the same elevation, as well as wonderful artsy weaving or braiding of belts.

Whatever parameters get tweaked by this should be displayed in the UI so it is posible to get a consistent bend between different belts
Welcome to Satisfactory Q&A, where you can ask questions and receive answers from other members of the community.
In order to keep this site accessible for everybody, please write your post in english :)
August 28th update: We've removed downvotes! One major reason is because we don't want to discourage folks from posting legitimate suggestions / reports / questions with fear of being mass downvoted (which has been happening a LOT). So we now allow you to upvote what you like, or ignore what you don't. Points have also been adjusted to account for this change.
Please use the search function before posting a new question and upvote existing ones to bring more attention to them, It will help us a lot. <3
Remember to mark resolved questions as answered by clicking on the check mark located under the upvotes of each answer.
...