+3 votes
97 views
in Suggestion by (120 points)
Please make mergers and splitters more easily attachable to conveyor belts that are suspended in the air.
by (1.2k points)
If you're just placing on an existing conveyor they should just snap on where you place them.

if you want to terminate at the splitter , extend the conveyout past the point , snap it on, delete the conveyor then re-extend the conveyor to the now hovering splitter.
by (120 points)
Thank you. That makes things a lot clearer and easier than what I was doing (customizing the length of the conveyor and then placing the splitter on the last pixel of it).

That said, I hope they fix the lack of a placement snap-grid. Last time I tried to do what you're talking about, I could place the splitter/merger anywhere along the conveyor (analog). I'd like to have the same grid as normally placing things (at least optionally) so I can get exact 90 degree angles.
by (1.2k points)
One option that I use is to stack splitters on a foundation in the shape I want , connect and that gives me the 90 degrees, I then just delete the splitters and re-work the conveyors
by (120 points)
That's a good tip albeit not applicable to the OP.
Welcome to Satisfactory Q&A, where you can ask questions and receive answers from other members of the community.
In order to keep this site accessible for everybody, please write your post in english :)
August 28th update: We've removed downvotes! One major reason is because we don't want to discourage folks from posting legitimate suggestions / reports / questions with fear of being mass downvoted (which has been happening a LOT). So we now allow you to upvote what you like, or ignore what you don't. Points have also been adjusted to account for this change.
Please use the search function before posting a new question and upvote existing ones to bring more attention to them, It will help us a lot. <3
Remember to mark resolved questions as answered by clicking on the check mark located under the upvotes of each answer.
...